Please find a downloadable pdf of error codes here:
| E01 | Flame sensor open circuited | Please connect the lead properly if it's loose. | |
| E02 | Flame sensor short circuited | Use multimeter to check if the flame sensor is short circuited or open circuited. Please repair or replace it if true. | |
| Use multimeter to check if the flame sensor is broken. Please replace it if true. | |||
| E03 | Flame temperature exceeds the maximum safe temperature | Check if the air inlet, outlet and the exhaust pipe are blocked. Please clean up if true. | |
| E04 | Flame temperature is lower than the minimum ignition temperature; ignition failure | Check whether there is fuel inside the tank. If not, please refuel. | |
| Check whether the fuel pipe is blocked, and whether the connection is correct. If not, please repair or replace it. | |||
| Check whether the fuel is frozen. If true, please use fuel suitable for low-temperature environment. | |||
| Check whether the exhaust pipe is blocked. If true, please clean it up. | |||
| Please replace the controller | |||
| E05 | Air sensor open circuited | Please check the plug of the air sensor. | |
| E06 | Air sensor short circuited | Please contact the dealer or manufacturer. | |
| E07 | Overhigh supply voltage | Use multimeter to check the voltage of power. If it's lower than DC 20V, please charge the battery or use a new one; if it's higher than DC 30V, please use a new battery. | |
| E08 | Over or low supply voltage | Use multimeter to check the voltage of power. If it's lower than DC 10V, please charge the battery or use a new one; if it's higher than DC 15V, please use a new battery. | |
| E09 | Glow pin grounded | Check if the glow pin is broken. If true, please replace it; use multimeter to check the resistance value between two leads of the glow pin. The value should be within 1-4 Ohm. Please replace it if not. | |
| E11 | Glow pin open circuited | Please connect the lead properly if it's loose. | |
| E12 | Fan motor open circuited | Please connect the electric motor plug properly if it's loose. | |
| E13 | Fan motor short circuited | Test (electrically) the electric motor to see if it operates properly. Please replace it if not. | |
| E14 | Electromagnetic pump failure | Please connect the lead properly if it's loose. | |
| E15 | Electromagnetic pump failure | Use multimeter to check the resistance value of fuel pump. It should be within 15-25 Ohm. Please replace it if the value is out of range. | |
| E16 | Heater offline (serial port error between the main board and the heater) | Please correct the serial connection. | |
| E17 | Altitude sensor failure (fail to read the altitude) | Please repair or replace the altitude sensor. | |
| E18 | Reserved | ||
| E19 | Boot failure of the heater | Please check whether there is fuel in the fuel tank; check whether there is carbon in the air outlet. If true, please clean the carbon; Aging of glow pin. | |